Funtravo Patio Heater Reflector Shield, Heat Focusing Reflector for Round Natural Gas and Propane Patio Heaters – for Extra Heat Reflecting Power

Price: $58.88 - $28.88
(as of Oct 26, 2021 18:13:25 UTC – Details)

Product Description

INSTALLATION INSTRUCTIONS

STEP 1 Make sure the the fittings (Screw Nut Clip and L Angle Bracket Corner Brace ) towards the hole as the pic. IMPORTANT: Prior to installation, you can install it with our online video.

STEP 2

Make sure the heater is cool and shut off or disconnect the gas source prior to installation. Locate the gas control knob on your patio heater. As shown in the diagram, position the middle clamp of your Heat reflector on the opposite side or approximately 180 degrees from the location of the gas control knob.Place the rim of the heater’s overhead reflector into the middle clamp. Tighten the screw until it is snug. Overtightening is not necessary and doing so may dent your heater.Verify that the clamp of your Heat reflector is installed on the opposite side of the gas control knob as shown or adjust the location as needed. Failure to follow these instructions can result in heater damage and personal injury.

STEP 3

Gently bend either side of your Heat toward the heater until the rim of the patio heater enters the clamp on that side, then proceed by tightening the thumb screw until snug. Repeat the same thing for the other side and you’re all done!Check the thumb screws often to make sure they have not loosened up and are still tightly fastened to the heater top.To remove your Heat just follow these same steps backwards. Loosen the side clamps first and then remove your Heat after untightening the middle clamp. Just remember, never handle your Heat while it’s hot. Touching your Heat while hot can result in personal injury

STEP 4

Always make sure all the clamps are fastened securely before turning on your patio heater. When ready to use, safely connect the gas and ignite your heater. Keep in mind that your heater will now deliver much more heat than it did before. Proceed with caution and do not stand or sit too close until you know how it performs. It may be best to start off with low heat at first to make sure you do not overdo it. Slowly increase the heat until you’re comfortable. Please remember to remove your Heat when not in use and do not have it installed in windy conditions above 5 miles per hour. If a heater is not properly secured there is a heightened risk of tipping.

LARGE SIZE

Large and Inconvenient.Funtravo Patio Heater Reflector Shield Size: 12.16inch x 33.86inch.The natural gas heat focusing reflector consists of 10 small heat reflector pieces, Whether your patio heater is round or square, this foldable patio heat reflector meets your needs. The adjustable heat focusing reflector is designed with folding, which is more convenient to use, store, and save space.

STURDY IN WINDY

Change the traditional use of four clamps to fix the heat reflector on the patio heater, but the use of more stable brackets with screws to fix, in even when there is wind, the natural focusing reflector will not easily fall off.

HIGH QUALITY & ADJUSTABLE—-Our patio heater reflector is made with high grade aluminum, very good to use, light and convenient, rustroof. Compare to others, a set of 10 pieces of adjustable design, freely to choose the blocking range area, and the foldable design, easy to carry and store, reduce your space. The smart screw clamp design, stay here safety, will not fall off in windy.
FIXED DIRECTION—-The patio heater reflector redirects the heat in the direction you want. Use Patio Heaters reflector to keep your propane running longer or more cheaply. Won’t waste extra heat.You will use less energy to enjoy the perfect amount of warmth.
HEAT FOCUSING REFLECTOR—-The patio heater reflector reduces invasion from rain and wind, and resistant to high temperatures, extend the service life of a space heater. And the heat focusing reflector redirects heat where you want it, block heat protects trees and walls from unwanted.
LARGE SIZE-Compared with other products(most are height 24cm), our height is 30cm, which can block heat more effectively. Extended heat range and increased efficiency for pation heaters.
EASY TO INSTALL—-You can install the patio heat focusing reflector easily by yourself with our online installation image. WARM TIPS: The reflector must be attached to your patio heater only on the opposite side to the on/off heat control knob. Otherwise the knob will start melting in under one minute.